
Bring a failed paver coat back to life
Paver Restoration and Resealing in Deltona, FL
Call (386) 272-6727 for a free estimate on stripping, re-sanding and resealing tired Deltona pavers.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can a local contractor restore my Deltona pavers soon?
Yes, a local contractor restores and reseals pavers around Deltona, FL, and replies come within 1 business day, frequently within a few hours. The free estimate comes with no pressure to book. To ask for a visit, call (386) 272-6727.
Restoration is for pavers that have been sealed before and now look worse for it: white haze, peeling edges, a sticky feel or a coat that has gone patchy in the sun. The job takes off what failed, packs the joints full again and puts down a fresh coat. Think of a driveway that looks half wet even when dry. Describe what you see when you request your free estimate.
What does restoration involve that a simple reseal does not?
Stripping what failed
A Tampa paver company says to apply a stripper that breaks the bond between the old sealer and the paver, then lift both with a surface cleaner and vacuum recovery. It also warns that sealing over failing layers makes the whitening worse. A Florida sealer guide says solvent sealers softened with xylene can sometimes be reworked, but water based ones have to be stripped. To ask which applies to you, call (386) 272-6727.
Which nearby towns can book paver restoration?

Why does sealer fail on Florida pavers?
Trapped moisture
A sealer guide says hidden moisture in joint or bedding material keeps sealer from bonding, which leaves cloudy spots that show when sprinklers run. Deltona gets about 51 to 53 inches of rain a year. A paver stripping company lists trapped water vapor first among causes of failure, mostly in oil based acrylic coats. To check whether yours is trapped, call (386) 272-6727.
What is the paver restoration process, step by step?
Restoration takes more steps than a reseal, and each one has to dry before the next. An Orlando company says a strip and reseal takes two to three days. To fit it around the forecast, call (386) 272-6727.
1. Inspect and test
The contractor marks sunk pavers, peeling edges and white patches, then tests a small spot to see what the old coat is made of.
2. Repair the base problems
Pavers that rock or hold puddles are lifted and reset. Sealer cannot fix them, as Unilock notes.
3. Strip the old coat
A stripper breaks the bond, and a surface cleaner with recovery lifts the residue.
4. Treat stains and wash
Algae, rust and tannin get cleaners matched to each. A low pressure wash follows.
5. Re-sand and dry
Coarse silica sand is wet in and the whole surface dries, a few hours in sun or about a day in shade.
6. Reseal and walk the job
Thin coats go on in one session. The contractor says when feet, furniture and cars can return.
What does paver restoration cost in Deltona?
An Orlando paver company lists a strip and reseal at $3.50 to $5.00 per square foot, compared with $1.50 to $3.00 for a standard clean, sand and seal. A Central Florida company says stripping failed sealer adds $500 to $1,000 or more and sets a $1,000 project minimum. At 800 square feet, a strip and reseal lands near $2,800 to $4,000. For a figure on your own pavers, request your free estimate.
The condition of the base moves the number most. Sunken pavers, loose edges and weeds through the joints all add time. A quote with no stripping line on a peeling driveway is worth questioning. Holding a quote? Call (386) 272-6727 and compare it with the table.
Curious about related work? See paver sealing, paver cleaning and joint sand or paver stain removal, check the towns served, or go back to Deltona paver sealing.
| Job on an 800 sq ft driveway | Published figure | Example total |
|---|---|---|
| Wash alone (general pressure washing) | $0.15 to $0.75 per sq ft | $120 to $600 |
| Standard clean, sand and seal | $1.50 to $3.00 per sq ft | $1,200 to $2,400 |
| Strip and reseal (Orlando list) | $3.50 to $5.00 per sq ft | $2,800 to $4,000 |
| Stripping failed sealer as an add on | $500 to $1,000 or more | $500 to $1,000+ |
| Correcting a failed earlier job | $1,000 to $3,500 added | $1,000 to $3,500 |
No page read for this site prices restoration under that name, so the table is built from the published pieces that exist: washing, a standard clean, sand and seal, a strip and reseal, and the stripping and correction add ons a Central Florida company lists. Rates were read in November 2026. Sunken pavers, edge repair and joint refills change the total, and one company sets a $1,000 minimum.

How do I know if I need restoration or just a reseal?
A reseal fits pavers that are clean, whole and simply thirsty: water soaks in, color is dull, but nothing is peeling. Restoration fits white haze, peeling, stickiness, patchy gloss or pavers that rock underfoot. A contractor can usually tell in a few minutes. Take a photo of the worst patch and request your free estimate.
Dull color after a wash is a hint too. When the wash lifts the dirt but the surface stays milky, the old coat is the problem. Put a few drops of water on the paver, and if it beads on a clean surface, a simple reseal may do. To get a second opinion, call (386) 272-6727.
Can a failed sealer be fixed without stripping?
Sometimes. A sealer guide says a solvent coat trapped by moisture or put on too thick may soften when rolled with xylene, after a patch test. The same guide says xylene does almost nothing to water based sealer, which has to be stripped. Heavy build up needs a heavy stripper. Ask the contractor to test a corner and explain the result before you request your free estimate.
How long should I wait after new pavers or heavy rain before restoration?
New pavers need patience. Unilock says to wait 60 to 90 days after installation and until any efflorescence has faded, usually two to three months and sometimes up to a year. After heavy rain, pavers need a few hours of sun to dry or about a day in shade. Deltona gets about 51 to 53 inches of rain a year, so give the surface time. To pick a dry window, call (386) 272-6727.
Clear skies matter after the coat goes on as well. Unilock asks for 24 to 48 hours of dry weather and for automatic sprinklers to stay off, since water can leave white marks or get trapped. Tell the contractor which sprinkler zones touch the pavers when you request your free estimate.
Does restoration cure low spots, rocking pavers or sunken joints?
Not by itself. Unilock states that sealing does not solve drainage or base problems, so low pavers get reset first. Deltona sits on karst land with rolling hills. Pavers that hold a puddle after rain need their base looked at. Ask whether leveling is in the price or billed on its own, and request your free estimate.
What do Deltona homes with older pavers usually face?
Deltona Lakes opened to land buyers on November 18, 1962, and a Central Florida realty guide describes an original core of 1960s to 1980s homes with mature oak and pine canopy. Older driveways and walks have usually seen more than one coat and more than one product. That history makes the test patch worth doing. To ask for one, call (386) 272-6727.
Pavers under heavy canopy stay damp, and damp pavers hold a failing coat in worse shape. A contractor may find dark algae under peeled edges. Mention the shade and where the leaves land when you request your free estimate.

What do restored pavers look like around Deltona?








Frequently Asked Questions
Should you seal pavers after power washing?
Only once they are fully dry and clean. Unilock says a freshly washed paver needs a few hours in sun or about a day in shade before sealer goes on, and that sealing too soon can trap moisture. A sealer laid over a damp or dirty surface can turn cloudy, so the wash and the sealer are two steps with a pause between.
How long does paver sealing last in Florida?
An Orlando paver company says two to four years, with a maintenance cleaning every 12 to 15 months to help the coat last. Cheap products can break down in 6 to 12 months in Florida sun, according to a Central Florida company. A restoration that strips the failed coat first gives the new one a clean start.
How much to clean and seal pavers?
Central Florida price lists show $1.50 to $3.00 per square foot to clean, sand and seal. Restoring a failed coat costs more because the old sealer has to come off first: $3.50 to $5.00 per square foot for a strip and reseal in one Orlando price list. Ask whether stripping and joint sand are on the quote.
What happens if pavers are not sealed?
They fade sooner, lose joint sand faster and take in stains. Pavers with a worn, patchy coat sit in between: part sealed, part bare. Restoration deals with that mixed surface so the new sealer cures evenly.
Is there a downside to sealing pavers?
Yes, a coat that goes wrong is harder to fix than no coat. Trapped moisture, a layer laid on too thick or a product that does not match the old one can leave white patches. Restoration removes those, but it adds cost, so the first coat is worth doing carefully.
Why is paver sealing so expensive?
Labor and preparation make up the bulk of the bill. Cleaning, joint sand, drying time and two coats take most of a day, and a strip and reseal takes two to three days according to an Orlando company. A quote far below the published range may skip steps, which is how failed coats happen.
Can a contractor clean, sand and seal my pavers in one visit?
Usually yes, for pavers that are in decent shape. An Orlando company says a standard job often finishes in one day. A failed coat changes that: stripping stretches the work to two or three days, and sunken pavers need repair before any of it.
Does a failed sealer on Deltona pavers always need stripping?
Not always, but often when the sealer is white, peeling or sticky. A paver pressure washing company says to strip all failed sealer before resealing, because sealing over failing layers makes the whitening worse. A contractor tests a small patch before deciding.
How do I know if my Deltona pavers need restoration instead of a reseal?
Look for white cloudy patches, peeling edges, a sticky feel or color that stays dull after a wash. If water just beads and the surface is clean, a simple reseal may do. Sunk pavers, weeds through joints and sand lost across the driveway point toward restoration.
What other paver services are offered in Deltona?
Ready to bring your pavers back from a bad coat?
Send a photo or your street and expect a reply inside 1 business day, usually within a few hours.
Free, no obligation
